Charcoal Embers; Battery Installation; Gdix3-1) - Napoleon GDI3N-1 Installation Manual

fi nishing
EN
3.8

charcoal embers

WARNING
!
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
note:
Charcoal embers are not to be placed on the burner.
3.9 battery installation (GDIG3-1 / GDIX3-1)
4 AA batteries must be installed into the receiver before the appliance can operate by battery backup. The re-
ceiver is located in the bottom right corner of the appliance (Fig. 3-3).
1. Remove the battery cover plate by pushing the two tabs that hold the cover in place.
2. Remove the 4 AA batteries in the battery holder and replace with new ones.
note:
Note the polarity of the batteries and insert as indicated on the cover (+/-).
3. Reinstall the cover plate.
GDIG3-1 Illustrated
3.10 battery installation (GDI3E-1)
1. Remove battery holder by sliding it forward from the
bracket (Fig. 3-4).
2. Install 4 batteries.
3. Reinstall battery holder.
24
W415-4083 / 03.31.22
Fig. 3-3
note:
Ensure the 3 position slider
switch is in the "REMOTE"
position (middle position).
Fig. 3-4
Bracket
Battery Holder