Glowing Embers; Charcoal Embers; Logo Placement - Napoleon GX36NTREA-1 Manual

NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
3
3
IF SPACE IS LEFT OVER, USE THIS BOX TO
SHOW CORRECT FINAL LOG
PLACEMENT WITH PHOTOS.
IF NOT, USE BOXES AS ABOVE.
8.7

glowing embers

WARNING
!
• Completely blocking the burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed
IF APPLICABLE, USE THIS BOX TO SHOW ignition.
"NATURAL GAS ONLY" LOG PLACEMENT.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
block off the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
Natural Gas Models Only:
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor. PLACE TEXT BOX HERE.
NOTE: ENSURE NOMENCLATURE IS
8.8

charcoal embers

CONSISTENT THROUGHOUT.
WARNING
!
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
note:
Charcoal embers are not to be placed on the burner.
8.9

logo placement

Remove the backing of the logo supplied and place, as illustrated.
2
2
4
4
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
2
3
3
IF SPACE IS LEFT OVER, USE THIS BOX TO
SHOW CORRECT FINAL LOG PLACEMENT
WITH LINE DRAWINGS.
IF NOT, USE BOXES AS ABOVE.
IF APPLICABLE, USE THIS BOX TO SHOW
"PROPANE ONLY" LOG PLACEMENT.
Propane Models Only:
PLACE TEXT BOX HERE.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
22.2
1/2"(12.7mm)
45.5
2
4
4
finishing
22.1A
48.3
INSERT
LOGO
IMAGE
1/2"(12.7mm)
HERE
W415-3097 / 07.06.21
EN
53