Table of Contents
Advertisement
NB18/NB24 Gas Log Set
CLEANING AND SERVICING
Annual inspection and cleaning by your dealer or qual-
ified service technician is recommended to prevent
malfunction and/or sooting.
WARNING
Turn off heater and allow to cool before cleaning.
Disconnect electrical power before cleaning or
servicing.
Remove logs, handling carefully by holding gently at each
end. Gloves are recommended to prevent skin irritation
from ceramic fibers. If skin becomes irritated, wash gently
with soap and water. Refer to manual for correct log
placement.
PERIODIC CLEANING - Refer to parts diagram for
location of items discussed below.
•
Do not use cleaning fluid to clean logs or any part of
heater.
•
Brush logs with soft bristle brush or vacuum with
brush attachment.
•
Vacuum loose particles and dust from the front and
rear burner, control and piezo covers and grate
weldment.
•
Inspect and clean burner air intake holes. Remove
lint or particles with vacuum, brush, or pipe cleaners.
Failure to keep air intake holes clean will result
in sooting and poor combustion.
•
External case should be dusted and wiped with a
wet soapy cloth.
Monessen • NB18/24 Gas Log Set Installation/Owner's Manual • 81D0107 • Rev B • 09/16
CLEANING AND SERVICING
ANNUAL CLEANING/INSPECTION - Refer to parts
diagram for location of items discussed below.
•
Inspect and clean burner air intake holes. Remove
lint or particles with vacuum, brush or pipe cleaners.
Failure to keep air intake holes clean will result
in sooting and poor combustion.
•
Inspect and clean all burner ports.
•
Inspect ODS pilot for operation and accumulation of
lint at air intake holes.
•
Verify flame pattern and log placement for proper
operation.
•
Verify smooth and responsive ignition of main burner
and rear burner.
•
Replace battery in remote control device.
41
Advertisement
Table of Contents
