Table of Contents
Advertisement
GRATE AND LOG INSTALLATION
6. Place top left log (#6) on left rear log (#4) and left front
log (#5) using locating grooves on bottom of #6 and
locating blocks on logs #4 and #5. Figure 25
7. Place right top log (#7) on right rear log (#3) and right
front log (#2) using locators on the bottom of log #7 and
locators on logs #2 and #3. Figure 25
Left Top Log #6
Figure 25
8. Place small right front top log (#8) on log #7 and log
LG626
place log 7
#2 using locating grooves on the bottom of log #8 and
locating blocks on log #7 and log #2. Figure 26
Figure 26
LG627
place log 8
Monessen • NB18/24 Gas Log Set Installation/Owner's Manual • 81D0107 • Rev B • 09/16
20
Right Top Log #7
Right Front
Top Log #8
PLACE THE DECORATIVE ROCK
Optional volanic rock may be placed around the unit on
the floor of the firebox. Be sure to avoid any areas on the
burner itself.
DO NOT sprinkle volcanic rock on the logs,
around the pilot, or on or near burners. This
may cause sooting. Place volcanic rock only
on the floor of the fireplace.
During initial operation of the new heater,
new burning logs and/or rock wool will give
off a paper burning smell and orange flames
will be present. Simply open the windows for
a few hours to vent the odor.
STONY CREEK SC18/24/30-R LOGS
PLACEMENT
1. Place bottom log (#1) on two (2) pins on rear of grate
assembly and push towards rear as far as possible.
Figure 27
Figure 27
2. Place the ember chunk (#2) with notch on both ends
on the grate bar right side of the burner adjacent to the
LG1065
Mon SC24R log 1
controls. Push towards rear as far as possible. Figure
28
3. Place the ember chunk (#3) with notch on one end on
the grate bar left side of the burner with notch towards
rear. Push towards rear as far as possible. Figure 28
Ember Chunk
Log #3
(Notch on
one end)
Figure 28
LG1066
Mon SC24R logs 2 3
NB18/NB24 Gas Log Set
Bottom Rear Log #1
Ember Chunk Log #2
(Notch on both ends)
Advertisement
Table of Contents
