Table of Contents
Advertisement
NB18/NB24 Gas Log Set
ROCK WOOL PLACEMENT
Before installing logs, place rockwool in dime size pieces
evenly over small burner ports starting in the rear of the
burner going towards the front. Avoid placing rock wool on
slots on each side of rear burner and on large yellow flame
ports on front of burner. After covering small burner ports,
discard any excess rock wool.
Wash hands after placing rock wool. Itching may occur.
NOTE: Installation instructions are the same for 18",
24", and 30" log sets. Pictures used in this manual
illustrate the 24" set. Some variation may exist between
the images and the set included with this manual.
WARNING
•
Use only rock wool provided with log set.
•
Do not add additional rock wool
Dime-sized pieces
of rock wool
Figure 19 -
Place Rock Wool
INSTALL 18", 24" AND 30" (F, R) BERKLEY
OAK LOGS ON NATURAL BLAZE BURNER
1. Place the #1 log (the "chunk") on the grate bar right side
of the burner adjacent to the controls. Figure 20
FP2269
2. Place front right log (#2) on right pin located on burner
place rock wool
and right grate bar. Figure 21. slide Log #1 forward so
that it is tight against log #2.
Figure 20 -
Place Ember Chunk Log #1
Monessen • NB18/24 Gas Log Set Installation/Owner's Manual • 81D0107 • Rev B • 09/16
LG620
place log 1
.
Ember Chunk
Log #1
LG620
GRATE AND LOG INSTALLATION
Figure 21 -
Place Right Front Log #2
LG630
3. Place right rear log (#3) on pin located on rear support
NB18/24 log 2
bracket and rest left side of log on front right log. Figure
22.
Right Rear
Log #3
Figure 22 -
Place Right Rear Log #3
LG631
4. Place left rear log (#4) on pin located on rear support
NB18 24 Log 3
bracket on left side. Figure 23
Left Rear
Log #4
Figure 23 -
Place Left Rear Log #4
LG632
NB18 24 Log 4
Right Front
Log #2
17
Advertisement
Table of Contents
