Table of Contents
Advertisement
NB18/NB24 Gas Log Set
Setting Privacy Code on Transmitter
Figure 56
The remote transmitter privacy code
is preset in factory. In the event of
activation or interference from other
nearby transmissions, change the
code using the following procedures
(learn function must be performed af-
ter changing the code):
1. Press the ON/arrow button and
the TIMER button at the same
time to enter privacy code setup
mode.
2. The setup display is shown in the
figure. The four digits on the top
stand for the privacy code. The default values of the
four digits will be all "1".
3. The first digit will be flashing upon entering the setup
mode. Push the ON button to toggle its value between
"0" and "9", and push the "OFF" button to jump to the
next digit. The next digit will then start flashing and the
first one stops flashing. Set up the four digits to your
choice between "0" and "9".
4. After setting up all the four digits, push "OFF" to finish
the process and return to the previous mode.
5. The Signature Command control board then needs to
re-learn the new setting.
Performing Learn Function
1. The RF receiver button on the control board in the
fireplace must be in the on position before the learn
function can begin (refer to figure for location). With
the Command Center master switch in the ON posi-
tion, use paper clip to depress the recessed button on
Control Board, one beep for RF receiver ON or two
beeps for RF receiver OFF.
2. Holding the OFF button on the Command Center while
turning on the master switch will activate the learn
function for the transmitter.
3. After the above op-
eration, two beeps
will be given and the
green LED on the
Command Center will
flash for 10 seconds.
4. During the 10 sec-
onds, press the OFF
button on the trans-
mitter to learn. An-
other two beeps will
confirm success.
Monessen • NB18/24 Gas Log Set Installation/Owner's Manual • 81D0107 • Rev B • 09/16
TOUCH SCREEN REMOTE CONTROL OPERATION — SCR MODELS
Figure 56
FP2661
set privacy code
Control Board
RF
Receiver
ON/OFF
Figure 57
Command Center
ON
LED
OFF
Battery Door
Master Switch
Figure 58
FP2650
command ctr ctrl brd
WARNING
Do not use two (2) or more remote control systems
in the same area with the same privacy code set-
ting, as they will communicate with each other.
This may cause the appliances to malfunction.
Resetting the transmitter
If the transmitter is not working properly, reinstall the bat-
teries to reset the transmitter.
1. Pull out at least one of the batteries.
2. Press any key on the screen to discharge.
3. Wait for 10 seconds and reinstall the batteries.
Pushing and holding any key for more than 10 seconds
until the display refreshes will also reset the transmitter.
n Functions and Operations
General
The TSTSC Remote Control has four (4) operating
modes: Manual, Timer, Thermostatic and Smart Mode.
The control system can be set to temperature range be-
tween 45° F and 90° F. The flame height can be adjusted
in the manual and thermostatic mode. The Smart Mode
will automatically adjust flame height according to the dif-
ference between Set and Room temperatures.
The transmitter will operate the remote receiver from 1
foot to a maximum of 30 feet. The distance is reduced
when batteries are low.
Manual Mode
Figure 59
In this mode, the TIMER/THERMO buttons will only dis-
play "TIMER" / "THERMO", without showing the time and
the SET temperature. Pressing the ON/up and OFF/down
buttons will change the flame height and turn on/off the
fireplace if the TIMER/THERMO buttons are not pressed
and flashing.
FP2650
command ctr ctrl brd
37
Advertisement
Table of Contents
