Summary of Contents for ICP DAS USA iWSN-110X Series
Page 1
Series Quick Start v1.0, February 2022 Packing List In addition to this guide, the package includes the following items: iWSN-110X Series Split-core CT Screw Driver (1C016) Module Module Name Split-core CT Module Name Split-core CT iWSN-110X-PCT-ME Without CT iWSN-110X-240-ME 8m, Φ24mm (200A), 1 pcs...
Page 2
Warning ICP DAS assumes no liability for any damage resulting from the use of this product. ICP DAS reserves the right to change this manual at any time without notice. The information furnished by ICP DAS is believed to be accurate and reliable.
Page 3
Wire and Buttons Switch Instructions Power on Power off Name Instructions Reserved, empty or shorted Split-core CT pin, no directionality, support measuring and charging function Extension bus Instructions Empty or connect Ext_Bus extension module Button Instructions Wake Manual wake up After pressing for 1~3 seconds, the Boot LED light will be on for 1 second and...
LED indicator The module provides one LED indicator. The table below will show the LED status. Indicators Status Instructions 500ms Illegal Node ID, please set the Node ID Blink to 1~31, and then power on. continuous Low battery power. 1. Please confirm whether the CT is lock into the “CT”...
Page 7
Boot Steps ○ ○ ○ ○ A. Please confirm the CT is locked into the module, and “Ext_Bus” is connected an extension module by audio line. (If there is no extension module, the “Ext_Bus” don’t be connected.) B. Adjusting DIP switch and set the parameter of communication, and switch “PWR”...
Page 8
CT or equipment connected in the secondary circuit. 2. The external CT’s are fragile, please handle with care. 3. The current input of the iWSN-110X series only supports the factory-attached CT. 4. To install CT’s correctly, please ensure the CT lines sequences is right before clip the CT’s onto the power cable of the monitoring equipment.