Hydraulic Chute Kit: Motor - pronovost P-992 Operator And Parts Manual

ASSEMBLY (cont'd)
Figure 32
Figure 33
Figure 34
HYDRAULIC CHUTE ROTATION
1) Install U-shaped UHMW piece , place chute on
Snowblower and secure with retaining bracket and
bolts provided.
2) Install the mounting plate; put the required spacers
between mounting plate and base of chute (see p. 35
to 40 for chute model). Do not tighten the bolts
immediately, they will be tightened at final
adjustment (Fig. 32).
3) Install motor and 9 tooth gear. The thickness of the 9
tooth gear is slightly more than the ring-gear. Make
sure it exceeds on both sides of the ring gear (Fig.
33).
4) Using the take-up screws, adjust gear to mesh
without bottoming. Tighten mounting plate bolts.
5) Install guard. It is important that the cushion valve
furnished with your chute rotation kit be installed.
Cushion valve has been pre set in plant at 1200 psi.
(Fig. 34).
6) If you install a hydraulic cylinder on the chute
deflector, use model 25TR08 cylinder.
7) Use the optional hose support plate no. TSB-74104
(Fig. 35).
Figure 35
- 15 -
Motor
4