XIEGU G106 Operation Manual page 6

1. MIC interface
Front Panel Facing G106
Note: There is a bias voltage at the MIC end, so it shall not be short-
circuited.
2. COM interface
3. ACC interface
Instructions for External Interface Connection
4. Key wiring diagram
Connect straight key/ morse key according to the diagram shown
in the figure above.
Note:
● If the connector of the straight key is a 6.5mm 2-pole plug, please
change it to a 3-pole 3.5mm stereo plug according to the wiring method
shown in the figure above, and connect the trigger end of the morse key to
the "Di" or "Da" terminal.
● Take care that direct use of the 2-pole to 3-pole adapter or incorrect
wiring may result the radio in CW transmission status all the time!
5
Di
D Da
Di
D Da
D