Step 14 Setting The Indoor Unit Addresses And The Installation Options - Samsung AM AN1PCH Series Installation Manual

Step 14 Setting the indoor unit
addresses and the installation options
You cannot set the indoor unit address and the installation
options at the same time. Set the address and option settings
separately.
Common steps for setting address and options
Entering option
setting mode
Temperature up
button
Temperature down
button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter option setting mode:
a Remove the batteries from the remote.
b While holding down the
(Temp down) buttons simultaneously, insert the
batteries into the remote control.
c The controller will display "On", "Auto", and "00"
when option setting mode is entered successfully.
2 Set the option values.
• The total number of available options are 24: SEG1 to
• Because SEG1, SEG7, SEG13, and SEG19 are the page
• Set a 2-digit value for each option pair in the following
Setting the
option values
Mode button
Fan speed up button
Fan speed down
button
(Temp up) and
CAUTION
SEG24.
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
order: SEG2 and SEG3 SEG4 and SEG5 SEG6 and
SEG8 SEG9 and SEG10 SEG11 and SEG12 SEG14
and SEG15 SEG16 and SEG17 SEG18 and SEG20
SEG21 and SEG22 SEG23 and SEG24
[SEG2, SEG3] [SEG4, SEG5]
[SEG11 , SEG12 ] [SEG14 , SEG15 ]
[SEG21 , SEG22] [SEG23, SEG24]
SEG1 SEG2 SEG3
0 X X
SEG7 SEG8 SEG9
1 X X
SEG13 SEG14 SEG15
2 X X
SEG19 SEG20 SEG21
3 X X
On (SEG1 to SEG12)
[SEG6, SEG8] [SEG9, SEG10 ]
[SEG16 , SEG17 ] [SEG18 , SEG20]
SEG4 SEG5 SEG6
X X X
SEG10 SEG11 SEG12
X X X
SEG16 SEG17 SEG18
X X X
SEG22 SEG23 SEG24
X X X
Off (SEG13 to SEG24)
English
25