Samsung AM AN1PCH Series Installation Manual page 11

3 Install the suspension bolts, depending on the ceiling
type.
CAUTION
• Make sure that the ceiling is strong enough to support
the weight of the indoor unit. Before hanging the unit,
test the strength of each attached suspension bolt.
• If the length of the suspension bolt is more than
4.92ft(1.5m), vibration prevention is recommended.
4 Screw eight nuts and washers to the suspension bolts,
making space for hanging the indoor unit.
CAUTION
• You must install all of the suspension rods.
• It is important to leave sufficient space in the false
ceiling to allow access for maintenance or repairs to
the drainage pipe connection, the refrigerant pipe
connection, or to remove the unit if necessary.
5 Hang the indoor unit to the suspension bolts between
two nuts. Screw the nuts to suspend the unit.
1
6 Check the level of the indoor unit by using a Level.
• A tilt of the indoor unit may cause malfunction of a
Ceiling support
7 Adjust the unit to the appropriate position, taking into
account the installation area for the front panel.
• Place the pattern sheet on the indoor unit.
• Adjust the space between the ceiling and the
• Fix the indoor unit securely after adjusting the level
• Remove the pattern sheet and install the front
When the installation template is made of paper
Slim 1way cassette
(Small, WindFree)
Air outlet side
Slim 1way cassette
(Medium, WindFree)
2
Air outlet side
2
Slim 1way cassette
(Large, WindFree)
Air outlet side
built-in float switch and water leaks.
Level
indoor unit by using a Tape measure.
of the unit by using a level.
panel.
Slim 1way cassette
(Small)
Air inlet side Air outlet side
Indoor unit
Jig Ceiling
Slim 1way cassette
(Medium)
Air inlet side Air outlet side
Indoor unit
Jig Ceiling
Slim 1way cassette
(Large)
Air inlet side Air outlet side
Indoor unit
Jig Ceiling
Unit: inch(mm)
Air inlet side
Indoor unit
Jig Ceiling
Air inlet side
Indoor unit
Jig Ceiling
Air inlet side
Indoor unit
Jig Ceiling
11
English