Tennant T3 Operator's Manual
Hide thumbs Also See for T3:

Advertisement

Quick Links

ENGLISH - ESPAÑOL - FRANÇAIS
T3/T3+
Automatic Scrubber
Fregadora Automática
Balayeuse Automatique
Operator Manual
Manual De Operador
Opérateur Manuel
(S/N 10372394-
)
The Safe Scrubbing Alternativer
Hygenic
R
Fully Cleanable Tanks
North America / International
9004170
Rev. 04 (05-2010)
*9004170*
www.tennantco.com
Home
Find... Go To..

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tennant T3

  • Page 1 ENGLISH - ESPAÑOL - FRANÇAIS T3/T3+ Automatic Scrubber Fregadora Automática Balayeuse Automatique Operator Manual Manual De Operador Opérateur Manuel (S/N 10372394- The Safe Scrubbing Alternativer Hygenic Fully Cleanable Tanks North America / International 9004170 Rev. 04 (05-2010) *9004170* www.tennantco.com Home...
  • Page 2 Minneapolis, MN 55440 Phone: (800) 553- -8033 or (763) 513- -2850 www.tennantco.com FaSK--PAK is a US registered and unregistered trademark of Tennant Company. Specifications and parts are subject to change without notice. Copyright E 2008, 2010 TENNANT COMPANY, Printed in U.S.A.
  • Page 3: Table Of Contents

    USING THE OFF--BOARD BATTERY CHARGER ......Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 4: Safety Precautions

    Do not modify the machine from its service agent or a similarly qualified person in original design. order to avoid a hazard. Tennant T3/T3+ (11- -08) Home Find... Go To..
  • Page 5: Safety Labels

    Flame Away. Keep Battery Compartment Open When Charg- SPINNING BRUSH LABEL - - ing. Located on scrub head WARNING: Spinning Brush. Keep Hands Away. Turn Off Pow- er Before Working On Machine. Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 6: Machine Components

    15. Squeegee Assembly 34. Wall Rollers 16. Solution Flow Control Knob 35. ec- -H2O System Indicator light (ec- -H2O Model) 17. Solution Tank Clean-Out Port 18. Squeegee Lift Lever 19. Battery Charge Receptacle (Option) Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 7: Control Panel Symbols

    FIG. 1 3. Carefully install the batteries into the battery compartment tray and arrange the battery posts as shown (Figure 2). Insert the two foam spacers along side the batteries as shown. Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 8: How The Machine Works

    IMPORTANT: If your machine is equipped with the normal water in the recovery tank. on- -board battery charger, make sure that the charger is properly set for your battery type before charging (See USING THE ON- -BOARD CHARGER). Tennant T3/T3+ (09- -08) Home Find... Go To..
  • Page 9: Brush And Pad Information

    Surface preparation pad (Maroon) -- This pad is for very aggressive floor stripping. FIG. 5 5. Check the squeegee blades for proper adjustment (See SQUEEGEE BLADE ADJUSTMENT). Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 10: Installing Brush/Pad

    Lock Pin FIG. 7 4. Turn the brush motor hub until the slot with the FIG. 10 spring clip is visible through the scrub head window (Figure 8). Spring Clip FIG. 8 Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 11: Installing Fast--Pak (Fast Model)

    NOTE: When filling the solution tank with a bucket, clogging up the supply hose. make sure that the bucket is clean. Do not use the same bucket for filling and draining the machine. Tennant T3/T3+ (03- -08) Home Find... Go To..
  • Page 12: Machine Operation

    OPERATING THE MACHINE 1. Turn the main power key switch to the on ( I ) FIG. 17 position (Figure 15). FIG. 15 Tennant T3/T3+ (09- -08) Home Find... Go To..
  • Page 13: While Operating Machine

    FOR SAFETY: When using machine, go slow on 7. For conventional scrubbing, turn the solution flow inclines and slippery surfaces. Wear non- -slip control knob to a desired flow rate (Figure 21). shoes. Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 14: Battery Meter

    Stop scrubbing and recharge bat- teries Solid red Contact Service Center 9. When transporting or storing machine, remove the squeegee assembly and hang it on the storage bracket (Figure 24). FIG. 25 Tennant T3/T3+ (05- -10) Home Find... Go To..
  • Page 15: Circuit Breaker / Fuses

    (Figure 29). FIG. 27 FIG. 29 NOTE: When using a bucket to drain the machine, do not use the same bucket to fill the solution tank. Tennant T3/T3+ (01- -08) Home Find... Go To..
  • Page 16: Draining Solution Tank

    1. To drain any remaining water from the solution solution tank filter, clean--out cap, fill--port covers tank, pull the solution tank level hose off the hose and hose. fitting as shown (Figure 32). FIG. 32 Tennant T3/T3+ (01- -08) Home Find... Go To..
  • Page 17: Charging Batteries

    Contact your battery supplier if not specified. To verify the setting of the charger profile: Connect the charger cord into an electrical receptacle, open the battery compartment and view the on--board battery charger LED display. FIG. 37 Tennant T3/T3+ (03- -08) Home Find... Go To..
  • Page 18 Abnormal Cycle* Blinking Fault detected * Blinking Blinking Blinking * See the On- -board Battery Charger Fault Codes table. When a fault occurs, the charger will also sound an alarm. FIG. 39 Tennant T3/T3+ (03- -08) Home Find... Go To..
  • Page 19: On--Board Battery Charger Fault Codes

    Contact Service Center. 100% LED flashes Abnormal cycle. Safety timer exceeded the 18 Battery maintenance required or replace while the 50% and hour charging time. battery. 75% LED’s are off. Tennant T3/T3+ (01- -08) Home Find... Go To..
  • Page 20: Using The Off--Board Battery Charger

    6. Connect the charger’s DC cord into the machine’s battery receptacle at the rear of the machine (Figure 42). NOTE: The machine will not operate once the battery charger is connected. FIG. 44 FIG. 42 Tennant T3/T3+ (03- -08) Home Find... Go To..

This manual is also suitable for:

T3+

Table of Contents