Maintenance - Masalta MDRS65 Series Instruction Manual

Maintenance

Maintenance
Masalta vibratory rollers are designed to work trouble-free for many years. But the
other important thing is to have regular maintenance listed in this chapter. We recommend
Masalta authorized dealers to complete all the maintenance and repair. Using authentic
replacement parts from Masalta, the use of counterfeit products can cause voiding of your
warranty. Before any maintenance on the machine, turn off the engine. Place the machine
on level ground, to ensure that the liquid level can be read correctly. Only use
recommended lubricants. In maintenance, ensure that the hand lever is securely locked
up.
Engine Maintenance
Maintenance engine according to the manual of engine manufacturer. Refer to the engine
operation and maintenance manual.
Maintenance: Every 8 hours or daily
1. Check for loose screws and nuts, if necessary, retighten.
2. According to the engine manufacturer's recommendations, inspect, clean and lubricate
the air filter element. If operating in worse dusty conditions, the filter elements should be
cleaned more frequently
Maintenance: Every 50 hours or a week.
1. The hydraulic oil and filters should be replace for the first time after 50 hours work
for the new machine, later replaced every 500 hours. Please refer to "Maintenance: The
first 500 hours", There are specific oil change methods.
2. Check the drive belt tension
2.1 Loosen the four screws of fixed pump bracket, and adjust screws until the proper
tension. Drive belt should be 5mm in the middle deflection between centrifugal clutch and
pump pulley. （Graph 4）
10