Motor Spindle Maintenance - Piergiacomi DPF-300 Instruction Manual

9.3

MOTOR SPINDLE MAINTENANCE

Make sure that the system is disconnected from the power supply before carrying
out any maintenance or adjustment work.
To access the motor spindle, open the electrical panel following the instructions in chap.9.
Then remove the 4 screw shown in Fig.20, that secure the protective casing, to access the motor spindle
mount.
FIXING SCREWS
- DO NOT LOOSEN THE SCREWS ON THE MOTOR SPINDLE MOUNT (FIg.21)
CAUTION: Any accidental tampering with the mount screws will require a new alignment of the
INTERCHANGEABLE GUIDE-CUTTER assembly.
For any motor spindle fault, please contact our technical support department to better assess the problem
encountered and determine whether the part must be overhauled or replaced
MOTOR SPINDLE MOUNT
Fig. 21
Page 22
DPF-300
MOTOR SPINDLE
INSTRUCTION MANUAL
MOTOR SPINDLE PROTECTIVE
AND INSULATING CASING
Fig. 20
SCREW SCREW
MOTOR SPINDLE
Rev. Date: 27/01/2020
SCREW
Rev.0