Table of Contents
Advertisement
6. USING THE MACHINE
Once the machine has been installed correctly (Chap.4) and the appropriate interchangeable guide and
cutter have been inserted (Chap.5), the machine can be operated from the front control panel Fig.10.
DISCONNECT
SWITCH
Switching on the machine
power indicator light turns on) and then press the green button I on the switch to start
the machine (the ORANGE indicator light on the workbench and the switch light turn on).
Switching off the machine
Turn the disconnect switch counterclockwise to disconnect the machine
from the power grid.
In case of immediate danger, press the EMERGENCY button.
To connect the operator's wristband to the ESD system, use the banana connector on the right.
ALWAYS KEEP FINGERS AWAY FROM CUTTER POINT "A" SHOWN IN FIGURE 11
Fig. 11
The operator must acquire a minimum of "practice" in order to use the machine correctly and satisfactorily.
Page 14
DPF-300
Always wear safety goggles, protective gloves and safety earmuffs when
using the machine.
CONTROL PANEL
POWER
INDICATOR
LIGHT
Switch on the machine by turning the disconnect switch clockwise (the white
Stop the machine by pressing the red button O on the switch.
WARNING!
EMERGENCY
BUTTON
MACHINE ON/OFF
SIWTCH
A
INSTRUCTION MANUAL
ESD
CONNECTION
PORT
Fig. 10
.
Rev. Date: 27/01/2020
Rev.0
Advertisement
Table of Contents
