Installing/Replacing The Guide And The Cutter - Piergiacomi DPF-300 Instruction Manual

5. INSTALLING/REPLACING THE GUIDE AND THE CUTTER

Make sure that the system is disconnected from the power supply before carrying
out any maintenance or adjustment work.
INTERCHANGEABLE
GUIDE
Before using the machine, check the thickness of the isthmus to be cut and then install the interchangeable
guide and cutter of the required size observing the steps below (Fig.9):
1. Remove the metal suction tube from the guide;
2. Loosen the 2 fixing screws (1) securing the interchangeable guide;
3. Pull out the interchangeable guide;
4. Loosen the 2 fixing screws securing head (2) and remove it;
5. Lock the spindle shaft using the 14mm wrench (3) included in the package;
6. Loosen the clamp using the 17mm wrench (4) included in the package; turn it counterclockwise;
7. remove the cutter and insert the new one; push it in completely and tighten it vigorously;
8. Perform the steps above in reverse making sure to respect the reference marks that indicate the correct
orientation of the head.
ATTENTION: the diameter of the cutter should match the thickness of the guide.
Page 13
DPF-300
INSTRUCTION MANUAL
STAINLESS
STEEL
SUCTION
TUBE
HEAD
REFERENCE
CUTTER
REFERENCE
Fig. 9
Rev. Date: 27/01/2020
Rev.0