Snapshot (For Video Recording) - JVC GR-DVM55EG Instructions Manual

50
EN
MENU Wheel
Display
SNAP MODE – P I N–UP
FRAME
FUL L
MUL T I – 4
MUL T I – 9
NOTES:
To remove the shutter sound,
pg. 38, 40.
Even if "MULTI-4" or "MULTI-9" is engaged,
Snapshot recording will be performed in the
FULL mode during Digital Zoom or Night-
Alive ( pg. 45).
If Snapshot recording is not possible, "
blinks when SNAPSHOT is pressed.
If Program AE with special effects (
is engaged, certain modes of Program AE
with special effects are disabled during
Snapshot recording. In such a case, the icon
blinks.
If SNAPSHOT is pressed when "DIS" is set
to "ON" ( pg. 39), the Stabiliser will be
disabled.
During playback as well, all snapshot modes
are available when "
to "OFF" in the Menu Screen (
However, the shutter sound is not heard.
When a cable is connected to the AV
connector, the shutter sound is not heard
from the speaker, however it is recorded
onto the tape.
VIDEO/DSC Switch
(GR-DVM75 only)
Power Switch
Lock Button
SNAPSHOT
Button
CAMERA Menu
GR-DVM75 only
"BEEP" on
"
pg. 46)
COPY" is set
pg. 42).
FOR RECORDING

Snapshot (For Video Recording)

This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the VIDEO/DSC Switch to "VIDEO" (GR-
DVM75 only), then set the Power Switch to "
while pressing down the Lock Button located on the
switch. Open the LCD monitor fully or pull out the
viewfinder fully.
2
Press the MENU Wheel in. The Menu Screen
appears.
3
Rotate the MENU Wheel to select "
Press it and The CAMERA Menu appears.
4
Rotate the MENU Wheel to select "SNAP MODE",
then press it.
5
Rotate the MENU Wheel to select the desired
Snapshot mode, then press it. Rotate the MENU
Wheel to select " RETURN" and press it twice. The
Menu Screen closes.
•The available Snapshot modes are as the same as
those on page 27.
SNAPSHOT RECORDING
1
Press SNAPSHOT.
is being taken.
If you press during Record-Standby . . .
.... "PHOTO" appears and a still image will be
recorded for approx. 6 seconds, then the
camcorder re-enters the Record-Standby mode.
If you press during Recording . . .
.... "PHOTO" appears and a still image will be
recorded for approx. 6 seconds, then the normal
recording resumes.
•Regardless of the Power Switch position ("
" "), Snapshot recording takes place using the
selected Snapshot mode.
•To use the flash (GR-DVM75 only),
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to
serial photography. (Interval between still images:
approx. 1 second)
The Motor Drive mode is disabled when "REC SELECT"
is set to " /
( pg. 41).
CAMERA".
appears while the snapshot
pg. 54.
" in the Menu Screen
(cont.)
"
" or