Safety; Safety Notices; Safety Instructions; Work Area Safety - Markusson RJ12 Owner's Manual

Safety

2 Safety

2 .1 Safety notices

This section contains safety information for the power tool . This manual contains WARNINGS, CAUTIONS and
IMPORTANT notes that are applicable for the safe operation of the power tool .
WARNING A warning tells you about conditions that can cause injury or death, if you do not obey the
instructions . Do not continue until all conditions are accepted and engaged .
CAUTION A caution tells you about conditions that can cause damage to equipment, if you do not obey the
instructions . Do not continue until all conditions are accepted and engaged .
IMPORTANT Important or noteworthy information that enables trouble-free and optimal use of the power tool .

2 .2 Safety instructions

WARNING Read all safety warnings, instructions, illustrations, and specifications provided with this power tool .
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury . Save all warnings
and instructions for future reference . The term"power tool" in the warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power tool .
WARNING Before you install, operate or do maintenance on the power tool, you must read the safety
information in this manual . Obey the instructions in this manual to prevent injuries or damage to the equipment .

2.2.1 Work area safety

WARNING Keep work area clean and well lit . Cluttered or dark areas invite accidents .
WARNING Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust . Power tools create sparks which may ignite the dust or fumes .
WARNING Keep children and bystanders away while operating a power tool . Distractions can cause you to lose
control .
WARNING Put the power tool in a dry indoor area with good lighting . Do not let the power tool become wet or
damp . Do not put the power tool near gas, liquids or other flammable materials .
WARNING The power tool must always be fixed to the floor . Make sure that it is safely attached .
WARNING Attach air hoses and cables with cable clamps, to make sure no one trips over them .
CAUTION Make sure that the floor where the power tool is placed is flat and level . When used with a stand,
attach the stand to the floor with screws .

2.2.2 Electrical safety

WARNING Power tool plugs must match the outlet . Never modify the plug in any way . Do not use any adapter
plugs with earthed (grounded) power tools . Unmodified plugs and matching outlets will reduce risk of electric shock .
WARNING Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and
refrigerators . There is an increased risk of electric shock if your body is earthed or grounded .
WARNING Do not expose power tools to rain or wet conditions . Water entering a power tool will increase the
risk of electric shock .
WARNING Do not abuse the cord . Never use the cord for carrying, pulling or unplugging the power tool . Keep
cord away from heat, oil, sharp edges or moving parts . Damaged or entangled cords increase the risk of electric
shock .
WARNING When operating a power tool outdoors, use an extension cord suitable for outdoor use . Use of a
cord suitable for outdoor use reduces the risk of electric shock .
WARNING If operating a power tool in a damp location is unavoidable, use a residual current device (RCD)
protected supply . Use of an RCD reduces the risk of electric shock .
5 RJ12_v1_EN_220223
RJ12