Set The Head-Tilt Angle; Set The Top-Plate Angle - Markusson RJ12 Owner's Manual

Operation
5 . Set the grinding wheel switch to OFF .
6 . Use the profile template to verify that the
grinding wheel has the same profile as the type
of chain to be sharpened .
7 . Repeat steps 4-7 until the grinding wheel profile
is the same as the selected profile on the
profile template .

5 .2 .2 Set the head-tilt angle

Note: Read the specifications from the chain
manufacturer to find out the recommended head-tilt
angle for your chain .
1 . Loosen the head-tilt angle knob located on the
back of the machine .
18 RJ12_v1_EN_220223
2 . Turn the grinding head to set the desired head-tilt
angle (50-90°) on the head-tilt angle scale . The
default head-tilt angle is 60° .
3 . Tighten the head-tilt angle knob .

5 .2 .3 Set the top-plate angle

Note: Read the specifications from the chain
manufacturer to find out the recommended top-plate
angle for your chain .
1 . Loosen the top-plate angle screw up to three
turns .
2 . Turn the grinding head to set the desired
top-plate angle (0-35°) on the top-plate angle
scale . The default top-plate angle is 30° .
3 . Tighten the top-plate angle knob .
RJ12