Table of Contents
Advertisement
5. Do not touch live electrical parts. Wear dry, insulating gloves. Do not touch the torch tip when
machine is plugged in. Do not wear wet or damaged gloves. Plasma uses high electric voltage
which can cause serious harm or death.
6. Protect yourself from electric shock. Do not use the plasma cutter outdoors. Insulate yourself
from the work piece and the ground. Use non-flammable, dry insulating material if possible, or
use dry rubber mats, dry wood or plywood, or other dry insulating material large enough to cover
the area of contact with the work or the ground.
7. Avoid inhaling fume. Some fume and dust created by plasma cutting contain chemicals known to
cause cancer, birth defects or other harm. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals, work in a well-
ventilated area, and work with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
8. People with pacemakers should consult their physician(s) before using this machine.
WARNING! Electromagnetic fields in close proximity to a heart pacemaker
could cause interference, or failure of the pacemaker. The use of a Plasma Cutter is
NOT RECOMMENDED for pacemaker wearers. Consult your doctor.
9. Ensure that the unit is placed on a stable location before use.
WARNING! If this unit falls while plugged in, severe injury, electric shock, or
10. Transportation Methods. Lift unit with the handle provided, or use a handcart or similar device
of adequate capacity. If using a fork lift vehicle, secure the unit to a skid before transporting.
CAUTION! Disconnect input power conductors from de-energized supply line
11. Exercise good work practices. The warnings, precautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot be built
into this product, but must be considered by the operator.
12. Do not use this machine for pipe thawing. This machine was not designed for pipe thawing and
will be a significant electrical & heat hazard if attempt is made to use for thawing pipe.
fire may result.
before moving the machine.
© Weldclass 2019 | E.&O.E. | Edition 1.0 2019.05
CF-45
P
29
Advertisement
Table of Contents
