Operation - Dimplex DCAC20T Instruction Manual

Operation

ON/OFF
After the power is turned on, the device will beep twice and enter standby state. In
standby state, all functions and displays will be off, and all buttons aside from the
On/Off button are invalid. In standby state, pressing the On/Off button once will
turn on the device. By default the power indicator light and the fan LED display
showing 10 levels of wind speed will turn on. All other functions remain off. To turn
the device off or back into standby state, press the On/Off button once more. If the
left/right function is turned on, the device will automatically return to centre point
before switching off.
SPEED DIAL
When the device is switched on, you can set the wind speed between 1-32 by
adjusting the speed dial. By rotating the dial to the right, the wind speed will
gradually increase. When the maximum wind speed is reached (32), a buzzer will
beep. If you keep rotating to the right after reaching max speed, the speed will no
longer increase and the buzzer will beep continuously. By turning the dial to the
left, the wind speed will gradually decrease. Once you reach the minimum wind
speed, the device will beep, and do so continuously. 5 Seconds after setting your
desired speed, the display will show the current wind speed. The default operation
of the speed dial is to change wind speed, however if you press the Timer button,
and enter the desired timer setting, the speed dial is also used to adjust the timer
setting.
TIMER SETTING
Press the Timer button to begin setting the timer on your device. When you press
this button, 'h' will light up on the LED display. Use the speed dial to choose the
timer setting between 0-12 hours. When adjusting the timer, rotating the dial to the
right will gradually increase the time length. When it reaches the maximum value (12
hours) the device will beep, and will do so continuously. Rotating the dial to the left
will gradually decrease the time length, and the device will beep, when you reach
the minimum timer setting. After entering the timer setting mode, the previous timer
setting will not yet be changed. The timer will only be reset when the timer value
is changed by the speed dial, and will take effect after pressing the timer button to
exit the function. After 5 seconds, the desired time setting will be displayed on the
LED screen. Once the timer is finished, the device will immediately enter standby
state. You can also use this function to schedule the device to turn on. Press the
Timer button when the device is in standby state, and follow the above process to
set a time to activate this function.
10