Related Manuals for Dimplex DCACE20R
Summary of Contents for Dimplex DCACE20R
- Page 1 DCACE20R Air Circulator w/Electronic Controls, Timer & Remote INSTRUCTION MANUAL PLEASE READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USING THE UNIT. www.dimplex.com.au...
-
Page 2: Table Of Contents
CONTENTS WARNINGS AND PRECAUTIONS STRUCTURE OPERATION CLEANING AND MAINTENANCE TECHNICAL REFERENCE DATA WARRANTY www.dimplex.com.au... -
Page 3: Warnings And Precautions
WARNINGS & PRECAUTIONS Warnings • Never place the unit near gas appliances, flames or • flammable liquids. • Never hit or shake the unit. Doing so may cause damage. • Never cover or obstruct the air inlet or outlet. • Doing so may cause overheating. - Page 4 WARNINGS & PRECAUTIONS • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
Page 5: Structure
STRUCTURE 1. Base 2. Buttons 3. LED indicator light 4. Remote receiver 5. Brand badge 6. Front grille 7. Remote control/holder 8. Rear housing 9. Fan body 10. Fan body 11. Power cord... -
Page 6: Operation
OPERATION CONTROL PANEL & REMOTE On/Off Oscillation Mode Fan Speed Timer button button button button button INDICATOR LIGHTS Fan Speed Timer Mode Oscillation On/Off indicator indicator indicator indicator indicator... - Page 7 OPERATION REMOTE CONTROL The remote control can be used to operate all functions. 1. Remove the battery cover at the back of remote control (Picture 2). 2. Insert the 3V CR2032 battery. 3. Replace the battery cover. ON / OFF This button is used to switch the unit on and off.
- Page 8 OPERATION MODE This button is used to switch between pre-set operating modes. By simply pressing the button, you can regulate the mode from NORMAL, NATURAL or SLEEP depending on your needs. The unit automatically starts in NORMAL mode. Normal Mode: Operates normally with the selected wind speed – Low, Med, High.
- Page 9 OPERATION 1. Remove the unit from its packaging 2. Plug the unit into a power outlet, a ‘beep beep’ will sound and the unit will be in standby mode. 3. Press the “On/Off” button to turn the unit On. 4. Press the “Fan Speed” button to change the fan speed (low, med, high). 5.
-
Page 10: Cleaning And Maintenance
CLEANING & MAINTENANCE CLEANING Over time, dust can accumulate on the rear grille cover and fan blades, which can affect the fans performance. It is recommended to clean the fan at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. -
Page 11: Technical Reference Data
The warranty period is 12 months from the date of purchase. For service advice, please contact the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd 1340 Ferntree Gully Road,...