3.1
LAN 1 and LAN 2 interfaces
All services (Audio, PAD, SNMP, NTP, etc.) can be configured freely for both network
interfaces.
For the LAN interface a RJ45 socket is used. The pin assignment of the
socket is shown below.
Pin assignment: ETHERNET INTERFACES LAN 1 / LAN 2
Socket: RJ-45
Pin
Signal
1
TX+
2
TX-
3
RX+
4
not used
5
not used
6
RX-
7
not used
8
not used
Electrical characteristics
Data out +
Recommendation: IEEE 802.3/Ethernet
Data out -
Data rate (Auto neg.): 10/100 Mbit/s
Data in +
Recommended cable: CAT5 or higher
Max. cable length: 100m
Data in -
13