3.1
LAN 1 and LAN 2 interfaces
All services (Audio, PAD, SNMP, NTP, etc.) can be configured freely for both
network interfaces.
For the LAN interface a RJ45 socket is used. The pin assignment
of the socket is shown below.
Table: LAN Interface
Pin
Signal
1
TX+
Data out +
2
TX-
Data out -
3
RX+
Data in +
4
not used
5
not used
6
RX-
Data in -
7
not used
8
not used
Electrical characteristics
Socket: Western 8 pin, RJ45
Recommendation: IEEE 802.3/Ethernet
Data rate (Auto neg.): 10/100 Mbit/s
Recommended cable: CAT5 or higher
Max. cable length: 100m
13