1. Manuals
  2. Brands
  3. PMFoundations Manuals
  4. Recording Equipment
  5. ER-808
  6. Assembly manual

PMFoundations ER-808 Open Hat Module Assembly Manual

Hide thumbs Also See for ER-808 Open Hat Module:
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
ER-808 – Assembly Guide
_____________________________________________________________________________________
PM Foundations ER-808 v1.4
Open Hat Module
_____________________________________________________________________________________
Page 1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ER-808 Open Hat Module and is the answer not in the manual?

Questions and answers

Related Manuals for PMFoundations ER-808 Open Hat Module

Summary of Contents for PMFoundations ER-808 Open Hat Module

  • Page 1 ER-808 – Assembly Guide _____________________________________________________________________________________ PM Foundations ER-808 v1.4 Open Hat Module _____________________________________________________________________________________ Page 1 of 5...
  • Page 2 ER-808 – Assembly Guide _____________________________________________________________________________________ Resistors Arrange the resistors by value on the workbench in the same order as listed in the BOM and install each numbered part for that value before moving onto the next. Choose R7 as 100k for a short decay and 1.2M for a long decay. Install the resistors on the TOP of the board.
  • Page 3 ER-808 – Assembly Guide _____________________________________________________________________________________ Trimmer resistors Install on TOP so the adjustment is accessible from the back edge. Electrolytic capacitors Install on the TOP. Make sure you orient correctly. The longer lead and/or the lead marked with a + needs to be inserted into the hole that has the “+”...
  • Page 4 ER-808 – Assembly Guide _____________________________________________________________________________________ _____________________________________________________________________________________ Page 4 of 5...
  • Page 5 ER-808 – Assembly Guide _____________________________________________________________________________________ Testing Install the ICs. Plug the module into the Bus PCB. Connect the L and R outputs of the Trigger/Output module to an amplifier or other listening device in your rack. Power on. Press the button to light and then build a pattern of steps (see User Guide). Start the sequence.

Table of Contents