1. Manuals
  2. Brands
  3. PMFoundations Manuals
  4. Recording Equipment
  5. ER-808
  6. Assembly manual

PMFoundations ER-808 Trigger/Output Module Assembly Manual

Hide thumbs Also See for ER-808 Trigger/Output Module:
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
ER-808 – Assembly Guide
_____________________________________________________________________________________
PM Foundations ER-808 v1.4
Trigger/Output Module
_____________________________________________________________________________________
Page 1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ER-808 Trigger/Output Module and is the answer not in the manual?

Questions and answers

Related Manuals for PMFoundations ER-808 Trigger/Output Module

Summary of Contents for PMFoundations ER-808 Trigger/Output Module

  • Page 1 ER-808 – Assembly Guide _____________________________________________________________________________________ PM Foundations ER-808 v1.4 Trigger/Output Module _____________________________________________________________________________________ Page 1 of 5...
  • Page 2 ER-808 – Assembly Guide _____________________________________________________________________________________ Resistors Arrange the resistors by value on the workbench in the same order as listed in the BOM and install each numbered part for that value before moving onto the next. Install the resistors on the TOP of the board. Take care not to mix up resistors which have similar color codes.
  • Page 3 ER-808 – Assembly Guide _____________________________________________________________________________________ Lighted switch Carefully insert the leads into the holes for the switch pins and LED pins. The plastic legs of the switch must be flat onto the surface of the PCB. Any plastic legs which are fouled by other component pins should be cut off so the switch can lie flat.
  • Page 4 ER-808 – Assembly Guide _____________________________________________________________________________________ _____________________________________________________________________________________ Page 4 of 5...
  • Page 5 ER-808 – Assembly Guide _____________________________________________________________________________________ Testing Install the ICs. Plug the module into the Bus PCB and power on. Press the button and it should light, press the Accent button and Trigger button should turn off. Press the button again to light and then select a step. Start the sequence and check that the Trigger Out jack sends a trigger when the step lights the Trigger button.

Table of Contents