PMFoundations ER-808 Assembly Manual

Pmf's tribute

Hide thumbs Also See for ER-808:

ER-808 – Assembly Guide

_____________________________________________________________________________________

PM Foundations ER-808 v1.4

Assembly Guide

_____________________________________________________________________________________

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the ER-808 and is the answer not in the manual?

Page 1 ER-808 – Assembly Guide _____________________________________________________________________________________ PM Foundations ER-808 v1.4 Assembly Guide _____________________________________________________________________________________ Page 1 of 4...
Page 2 ER-808 – Assembly Guide _____________________________________________________________________________________ 1. Introduction This is PMF’s tribute to the Roland TR-808, as a Eurorack-compatible module composed of a panel and a set of build-it-yourself PCBs. Thank you for purchasing this module! Some of the pads are quite small and you will need a chisel tip or screwdriver tip soldering iron, 0.5mm solder and the skill to solder these tiny joints.
Page 3 ER-808 – Assembly Guide _____________________________________________________________________________________  External Trigger/Output module  Bass  Snare  Low Tom  Mid Tom  High Tom  Rim  Cowbell  Clap  Closed Hat  Open hat  Cymbal 3. General construction procedures Each module has its own build manual and BOM.
Page 4 ER-808 – Assembly Guide _____________________________________________________________________________________ Place the front panel so that the jacks, pots, switches and LED align with the holes in the panel. Put nuts on the jacks and pots. Install the knobs. _____________________________________________________________________________________ Page 4 of 4...