Connection To Teledyne Isco Instruments; Connecting To The Combiflash® Rf200; Preparing The Rf200 Connection Ports; Connecting The Rf Ports To The Elsd - Teledyne 340CF ELSD Installation And Operation Manual

3.3 Connection to
Teledyne Isco
Instruments
3.3.1 Connecting to the
CombiFlash® Rf200
Figure 3-2 Preparing the Rf200 connection ports
Figure 3-3 Connecting the Rf ports to the ELSD
This section provides information specific to connecting the
ELSD unit to a Teledyne Isco instrument.
The CombiFlash Rf200 uses RFID (Radio Frequency Identifi-
cation) technology to automate setting the parameters for purifi-
cation runs and fraction collection.
To connect the ELSD to the Rf200:
1. On the Rf200, disconnect the tubing assembly from ports C
and D. (Retain the tubing assembly in case it is needed
again later.)
Disconnect
ports C & D
2. Connect the shorter tubing assembly to port C, and the lon-
ger tubing assembly to port D.
3. Connect the other ends of the tubing to either side the tee
fitting on the rear panel of the ELSD.
183cm
60cm
340CF ELSD
Section 3 Installation
3-3