Table of Contents
Advertisement
340CF ELSD
Section 4 Operation
STANDBY
Set: 05min
4-6
ready or from ready to not ready. The alarm is 10 short beeps
repeated every 30 seconds. Pressing the
alarm.
Timer Page
COUNTDOWN
05:00
1 min to 60 min
▲
▼
Use
or
keys to extend or reduce countdown interval.
Push
|
MENU
POWER
but cancel countdown and return to home screen.
Push
AUTOZERO
interval and go back Home screen.
The timer default value is 5 minutes and is the recommended
time. The time can be increased up to 60 minutes or decreased
down to 1 min.
Filter Page
OFF, 1 to 10, FLT or BFT
▲
▼
Use
or
keys to select an action.
Push
|
MENU
POWER
screen.
Push
AUTOZERO
screen.
There are two filter types to choose from FLT and BFT. The filter
type is selected at the top of the menu after weight 10. Select FLT
or BFT and push the
filter menu again and selected the appropriate filter weight.
Filter weight is the level of baseline noise filtration. OFF indi-
cates no filtration. 10 is maximum filtration. In most cases, select
BFT for baseline filtering. The FLT setting applies a RC filter to
the entire signal. For high-speed chromatography, less than a 5
sec peak width, select BFT and turn the weight OFF. If the peak
widths are 5 to 30 seconds use the BFT filter with a weight of 1 to
10. For peak widths greater than 30 seconds, select the FLT
setting with a weight of 1 to 10. When the baseline filter is on, a
dramatic operation condition change (e.g. turning on/off attached
equipment), may upset the filter and cause baseline drifting. The
baseline will stabilize again in a few minutes.
DEPRESS PWR button 5
sec to turn off ELSD
key to save the modified countdown interval
key to cancel the countdown, keep the previous
Filter Weight:
1
key to take an action and go back Home
key to keep the current state and go back Home
|
MENU
POWER KEY
key resets the
AUTOZERO
to enter. Then enter the
Advertisement
Table of Contents
