Teledyne 340CF ELSD Installation And Operation Manual page 33

Spray Chamber Page
SPRAY CHAMBER
10.0°C
The reading under SPRAY CHAMBER is the current temper-
ature. The reading under SET is the setpoint.
▲ ▼
Pushing or keys to change a setpoint at 1°C increment.
Pushing |
MENU POWER
Home screen.
Pushing key to abolish the change and go back to
AUTOZERO
Home screen.
Drift Tube Page
DRIFT TUBE
40.0°C
The reading under DRIFT TUBE is the current temperature.
The reading under SET is the setpoint. The temperatures of the
optical cell and the exhaust tube are controlled at the same tem-
perature as that of DRIFT TUBE but their maximum temper-
ature is limited.
▲ ▼
Pushing or keys to change a set point at 1°C increment.
Pushing |
MENU POWER
Home screen.
Pushing key to abolish the change and goes back to
AUTOZERO
Home screen.
Control Page
Power Control:
[Run], [Standby], [Laser Off] or [Laser On], [Turn off Sound] or
[Turn on Sound]
▲ ▼
Use or keys to select an action.
Push | key to take an action and go back Home
MENU POWER
screen.
Push key to keep the current state and go back Home
AUTOZERO
screen.
If the display reads Laser Off or Laser On, pushing
key will turn the laser off or on. The laser may take up to 30
minutes to stabilize when it has been turned off, and on again.
If the display reads Turn off Sound or Turn on Sound, pushing
| key will turn the status alarm off or on. The status
MENU POWER
alarm sounds when the detector status changes from not ready to
Section 4 Operation
SET
10°C
key to accept the change and go back to
SET
40°C
key to accept the change and go back to
[Run]
340CF ELSD
|
MENU POWER
4-5