Advertisement
Available languages
Available languages
Installation instruction
Connect 50/70 backset and striking plate 1264 and 1487
Mortice instruction
A
1. Mark center line A (Face plate) when you have decided the position of the lockcase.
B
2. Put template along dotted line E and place on leading edge on the door, mark cylinder
and handle hole B and C according to the backset of lock you are fitting. This is a mortice
C
lock according to SIS 817383=symmetrical mortice (acc.to drawing).
3. Mark hole for faceplate where centerline A crosses template line F.
4. Use a 20 mm drill bit to get the correct depth for the lockcase. 78 mm for 50 mm
backset and 98 mm for 70 mm backset. IF fitting an electromechanical lock or micro-
switched lock add 100 mm to the dept. Do not use force to push the lockcase into the
mortice.
5. Drill the 42 mm hole for cylinder and handle through the door.
A
B
6. If you are installing the 2002 special sash lock. Mark and drill hole D. Do not drill through
the door, only to the centre of the door from the inside.
7. Mortice the faceplate into the edge of the door, this has a depth of 3 mm and radius 11.
C
8. Put the template for the strike plate acc. drawing. Make sure measure S is 2-4 mm. Make
the mortise according to strike plate drawing beside. Use a chisel to fit the strike plate
into the mortise. Use a chisel to make the outer profile according to drawing. Important!
Handing of latches and anti thrust bolt
1.
2.
3.
Loosen screw
Push latch/latches
Turn latch/latches
(torx T10) and
into the lock case
180° .
remove.
with your finger and
tighten the screw.
Placement of lock case in door blade
50 mm
3 mm
Non rebated
– use plane strike plate
ASSA recommends a
clearance of 3 mm
between forend of lock
Ø42
case and strike plate.
How to amount Lock shield
Lock shield LS 12209.
Align the LS with lower edge
Lock case
Only for Connect
of the lock case with longest
– backsets 50 and
side against the faceplate
70 mm
– as shown.
Adjustment of hook bolt clea-
rence hole. Push the screwdri-
ver in slot and bend carefully.
4.
5.
Latch/latches
To handing the anti
turned.
thrust bolt repeat
step 1-3 by using
screw acc to pic 5
instead.
50mm
3 mm
Rebated door
– use an angled strike plate
Ø42
After assembling
the lock attach the
lock shield sticker
somewhere on the
door well in sight
from outside.
Push on the upper edge with your thumb
until it clicks in to place. Make sure that
the LS are assembled on to the side which
Hinges to the right
is facing the outside of the door.
= Right handed
Adjustment of latch bolt clea-
rence hole. Push the screwdriver
in slot and turn carefully.
Maintenance secures
the functionality
For detailed information see
our homepage www.assa.se
Hinges to the left
= Left handed
Scale 1:1
!
Do not copy! Size may change.
ASSA will not be responsible for a
copied installation instruction.
!
Advertisement
