Assa Abloy Sargent 52-4424 Replacement Instructions
Assa Abloy Sargent 52-4424 Replacement Instructions

Assa Abloy Sargent 52-4424 Replacement Instructions

S1/s2 replacement controller instructions

Advertisement

S1/S2 Replacement Controller Instructions

52-4424, 52-4425, 52-4426
This controller has been configured as a generic replacement.
The serial number MUST be changed before it can be used!
(For serial configuration see Step #12.)
1.
On the inside of the door, remove the battery cover's security screw.
2.
Lift and remove the battery cover.
3.
Remove inside lever (if present).
4.
Remove through-bolt screws on top and bottom of
escutcheon.
5.
Disconnect gray ribbon cables, green grounding wire,
motor harness, DPS harness, and hard-wired harness/PoE
(if present). Remove inside assembly from the door.
6.
Remove the four (4) Philips screws holding the original
controller in place. Remove controller.
7.
Seat the controller into inside escutcheon. Attach with
the four (4) original Philips screws.
FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com
1
A8094A
Security Screw
Through-bolt Screws

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sargent 52-4424 and is the answer not in the manual?

Questions and answers

Summary of Contents for Assa Abloy Sargent 52-4424

  • Page 1 S1/S2 Replacement Controller Instructions 52-4424, 52-4425, 52-4426 This controller has been configured as a generic replacement. The serial number MUST be changed before it can be used! (For serial configuration see Step #12.) On the inside of the door, remove the battery cover’s security screw. Lift and remove the battery cover.
  • Page 2 S1/S2 Replacement Controller Instructions 52-4424, 52-4425, 52-4426 Reconnect the keypad harness, ground wire, DPS harness, motor harness, and hard-wired/PoE harness (if present). Mount the inside escutcheon back on the door using the two through-bolt screws. Reattach lever (if applicable). Install batteries and battery keeper (if applicable). Using Lock Configuration Tool (LCT), connect to the new controller.

This manual is also suitable for:

Sargent 52-4425Sargent 52-4426

Table of Contents