Problems And Solutions - Caple PI3050 Instruction Manual

PROBLEMS AND SOLUTIONS

Below are listed some possible fault messages
for which it is necessary to seek technical
support.
Cooking zone temperature sensor:
• Short-circuit: in the corresponding cooking
zone, the symbols "F" and "1" are alternatively
visualized.
• Open circuit: in the corresponding cooking
zone, the symbols "F" and "2" are alternatively
visualized.
• No operation: The corresponding heater display
alternates between an 'F' and a "7"
Power temperature sensor:
• Short-circuit: if the 2 elements controlled by the
induction generator are in short-circuit, "F" and "3"
are visualized alternatively.
• Open circuit: if the 2 elements controlled by the
induction generator have an open circuit, "F" and
"4" are visualized alternatively.
• Loss of zero crossing detection: the display
of the 2 heaters controlled by the induction
generator with which communication has been
lost alternates between 'F' and '8'.
Comunications loss:
• If the 2 elements controlled by the induction
generator lost comunications, "F" and "5" are
visualized alternatively.
Generator overcurrent:
• if the 2 elements controlled by the induction
generator are overloaded, "F" and "9" are
visualized alternatively.
Generator overheating:
• if the 2 elements controlled by the induction
generator are overheated, "POWER LEVEL" and
"C" are visualized alternatively.
Afterheat:
For safety reasons these information are the most
important.
• If the hob is switch off, the zones which show
the power are fixed on "H".
• if the hob is switch on, the zones which show
the power visualize alternatively "H" and "0".
If the power level is not "0", in the display is shown
the selected level.
Cooking zone without or with an inadequate
pot:
• In case of unsuitable pot or absence of pot in the
cooking area, the display will show the symbol
Authomatic actions in case of failure:
If there are failures on the temperature sensor
and on the cooking zones power sensor, these
immediately are switch off and the keys (+/-) are
blocked.
This happens also if there are loss of
comunication with the induction generator or
overloading.
If a cooking zone without a pot is selected for
more than 30 seconds, passed this time the
zone will automatically switch off.
27