Sony DCR-TRV19 Operating Instructions Manual page 96

Inserting a scene from a VCR – Insert editing
The POWER switch should be set to
Operate by touching the panel.
(1) On the VCR, locate just before the insert start point [a], then set the VCR to
(2) On your camcorder, locate the insert end point [c], then set it to playback
(3) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
(4) On your camcorder, locate the insert start point [b].
(5) Press FN and select PAGE3.
(6) Press REC CTRL.
(7) Press REC PAUSE.
(8) First press X on the VCR, and after a few seconds press REC START on your
To change the insert end point
Press ZERO SET MEMORY on the Remote Commander again after step 4 to erase the
ZERO SET MEMORY indicator and begin from step 2.
To insert a scene without setting the insert end point
Skip steps 2 and 3. Press x on the Remote Commander or
when you want to stop inserting.
96
playback pause.
pause.
MEMORY indicator flashes and the end point of the insert is stored in memory.
The tape counter shows "0:00:00."
camcorder to start inserting the new scene with sound.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically stops recording and the point you set in step 3 is
cleared from memory.
3
ZERO SET
MEMORY
.
0:00:00
ZERO SET
MEMORY
on your camcorder