Sony DCR-TRV19 Operating Instructions Manual page 192

Types of trouble and how to correct trouble
Others
Symptom
A title is not recorded.
A cassette label is not recorded.
Digital program editing to the tape
does not function.
Digital program editing to the
"Memory Stick" does not function.
(DCR-TRV22/TRV33 only)
The Remote Commander supplied
with your camcorder does not
work.
The picture from a TV or VCR
does not appear even when your
camcorder is connected to the
outputs on the TV or VCR.
192
Cause and/or Corrective Actions
• The cassette has no Cassette Memory.
c Use the cassette with Cassette Memory (p. 101).
• The Cassette Memory is full.
c Erase unnecessary title (p. 102).
• The cassette is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible (p. 198).
• The tape has a blank portion in the recorded portion.
c Superimpose the title to the recorded portion (p. 101).
• The cassette has no Cassette Memory.
c Use the cassette with Cassette Memory (p. 104).
• The Cassette Memory is full.
c Erase unwanted data (p. 105).
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible (p. 198).
• The input selector on the VCR is not set correctly.
c Set the selector correctly, then check the connection
between the VCR and your camcorder (p. 81, 92).
• Your camcorder is connected to DV equipment of other
than Sony using the i.LINK cable.
c Set it to IR (p. 85).
• Setting program on a blank portion of the tape is
attempted.
c Set the program again on a recorded portion (p. 90).
• The synchronization of your camcorder and the VCR is
not adjusted.
c Adjust the synchronization of the VCR (p. 88).
• The IR SETUP code is not correct.
c Set the correct code (p. 87).
• Setting program on a blank portion of the tape is
attempted.
c Set the program again on a recorded portion (p. 130).
• COMMANDER is set to OFF in the menu settings.
c Set it to ON (p. 184).
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted in the battery holder with the + –
polarities not matching the + – marks.
c Insert the batteries with the correct polarity (p. 217).
• The batteries are dead.
c Insert new ones (p. 217).
• DISPLAY is set to V-OUT/LCD in the menu settings.
c Set it to LCD (p. 184).