Server TABASCO 88521 Cleaning Instructions

DISMANTLING CLEANING INSTRUCTIONS
Clean, rinse, sanitize and dry all parts before first use and after use daily. Wash, rinse & sanitize to local
health department regulations.
1
Loosen locking collar
and remove cylinder
from head assembly.
Remove O-ring from
seal. Note this seal may
be red or blue in color.
8
Using supplied
brushes, fully wash
all parts with deter-
gent and hot water.
For questions regarding pump, reference the manual or contact customer service at (800) 558-8722.
Server Products, Inc. | 800.558.8722 | spsales@server-products.com | server-products.com
PUMP CLEANING INSTRUCTIONS
TABASCO
®
2
Remove spring from
cylinder.
5
Remove gaging collar
from head assembly.
9
Fully rinse all parts
with clear water.
PUMP 88521
Remove pinch valve
from head assembly -
pinch and gently turn
while pulling.
6
Sanitize parts following local
sanitation requirements.
3
Take seal off of head
assembly by pressing
down with thumb. Do not
use sharp tool.
7
Fully disassembled pump.
Allow parts to fully air dry after
10
sanitation.
Reassemble pump by reversing
dismantling instructions.
When installing seal, flared end
should be down, away from piston
head.
When installing plastic cap onto
cylinder, press down firmly until it's
past the threading.
4
Manual 01958-RevA 100215