Secure The Device; Connections; Power Supply; Dmx - GLP VOLKSLICHT R-G-B Instruction Manual

2.2 Secure the Device

Regardless of the mounting method of the
stipulated safety wire. Therefore you have to pull the safety wire through to two
provided holes on the bottom side of the system and connect it with the truss-
support. Pay attention to a safe and proper fastening. Install a safety wire that
can hold at least 10 times the weight of the fixture. Never use the carrying
handles for this purpose.
The safety wire must be attached in a way that the height of drop is
minimised. A height of drop of more that 0.2m is strictly forbidden (
810-3).

2.3 Connections

2.3.1 Power Supply

~100-240 Volt AC, 50-60 Hz, earth contact type plug - Powercon
Connected load 140 VA (W) <=> T2A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.

2.3.2 DMX

USITT DMX-512 Standard input/output in 3 pole connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
The DMX- Addressing starts at the DMX- Address [001].
GLP German Light Products GmbH
R - G - B
R - G - B
R - G - B
V
V
(Instruction version 1.0) / from software version 1.08)
O L K S L I C H T you'll have to use a
O L K S L I C H T
BGI
8