Table of Contents
Advertisement
SDP-3 Digital Surround Processor/Controller
If the two silent bands are too close, lower the
Speaker Angle; if they are too far apart, raise
the Speaker Angle.
L/R Balance
Zone 2 L/R Balance
If your normal listening position is not centered between your two front
speakers, once you have corrected the speaker angle setting, you can
"move" the sweet spot to that position. To do this, select LISTENER
POS and use
and
the display will indicate motion to the left of center
(L001,L002,L003...L127), CENTER, or to the right of center
(R001,R002,R003...R127). The numbers represent approximately
1/3", but are provided primarily as a general reference.
Panorama is now calibrated. Press DONE repeatedly to step back to the
main setup menu.
This control allows you to adjust the left/right balance of the front, side
and rear main outputs. This control can also be accessed on the remote
by pressing and holding the Shift button and using DONE to move to the
left, and SELECT to move to the right.
This control allows you to adjust the left/right balance of the Zone 2
outputs. This control can also be accessed on the remote by pressing
and holding the Record/Zone 2 button and using DONE to move to the
left, and SELECT to move to the right.
to move the effect. As you adjust the position,
S ystem
Configuration
31
Hide quick links:
Advertisement
Table of Contents
