Zone 2 Power On Volume; Setting Listener Position - JBL SDP-3 Installation & Technical Manual

System
Configuration
Mute Level
Power On Volume

Zone 2 Power On Volume

Setting Listener Position

SETUP MENU
INPUT CONFIG
SPEAKER CONFIG
OUTPUT LEVELS
LISTENER POSITION
LOCK SETTINGS
Speaker Distance
28
This menu allows you to set the level of attenuation used whenever the
SDP-3 MUTE function is engaged.
attenuation levels of -10dB, -20dB, -30dB, -40dB, and FULL are
available.
This control in the Output Levels menu allows you to select the volume
at which the SDP-3 will power on. You can choose from a range of -80
to +6dB, or elect to have the system power on at the last level used
(LAST LVL).
This control in the Output Levels menu allows you to select the initial
volume level for Zone 2. You can choose from a range of -80 to +12dB,
or elect to have Zone 2 power on at the last level used (LAST LVL).
The Listener Position menu is used for setting the surround and center
delays and calibrating the Panorama effect.
LISTENER POSITION
SPEAKER DISTANCE
A/V SYNC DLY
CALIBRATE PANORAMA
L/R BALANCE
ZONE 2 BALANCE
The Speaker Distance control automatically sets the appropriate time
delays for all of the loudspeakers in a system. Although this adjustment
is not a substitute for proper speaker placement, it will help to ensure
accurate signal arrival times from all channels at the listening position.
To set up Speaker Distance, you may physically measure the distance
from the primary listening position to the front baffle of each individual
speaker in your system. An easy and accurate way to accomplish this
is to have a person sit in the primary listening position, holding the end
of a measuring tape, while a second person extends the tape measure
to the front baffle of each speaker in turn.
To enter these values, select SPEAKER DISTANCE in the Listener
Position menu and press SELECT. Use
meters and press SELECT. Press SELECT again to highlight NEAR-
EST SPKR. Use and
DONE.
In the Output Levels menu,
Adjust with
based on speaker distance
OFF
Off, 1 to 30ms
CAL NOISE, SPEAKER ANGLE, LISTENER POS
< | >
[ _ _ _ | | _ _ _ ]
< | >
[ _ _ _ | | _ _ _ ]
and to highlight feet or
to enter the actual distance, then press
JBL Synthesis
or