Table of Contents
Advertisement
SDP-3 Digital Surround Processor/Controller
Restore Factory Defaults
Equalization
MAIN MENU
EFFECT ADJUST
EQUALIZATION
DISPLAY ADJUST
SETUP
Bass and Treble Level
System Configuration
Although the SDP-3 memory is cleared before it leaves the factory, it is
good practice to restore the factory defaults with the following procedure
before system configuration.
Turn the SDP-3 OFF with the remote control. Turn the unit back ON and
immediately press and hold the MUTE button on the remote. (Make sure
you do not block the infrared receiver on the SDP-3 front panel.) The
display will read:
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
Press
to highlight RESTORE DEFAULTS, then press SELECT. This
will clear and reload all preset effects and all factory settings of Volume,
Balance, Contrast, Configuration, etc. When the message FACTORY
DEFAULTS RESTORED is displayed, press DONE to return to normal
operation.
In the main menu, press SELECT to open the Equalization menu which
contains Bass, Treble and Tilt controls, and a Loudness parameter.
EQUALIZATION MENU
BASS LEVEL
TREBLE LEVEL
TILT
LOUDNESS
Bass and Treble level controls are provided to compensate for inconsis-
tencies in source material, rather than variations in room conditions. The
BASS LEVEL control allows a boost or cut of as much as 6dB below
250Hz. The TREBLE LEVEL control allows a boost or cut of 6dB above
1.5kHz. To select either control for adjustment, use
control, press SELECT, and use
These controls do not affect the sound of rear or side speakers.
Adjust with
+0.0dB
-6.0 to +6.0dB
+0.0dB
-6.0 to +6.0dB
+0.0dB
-3.0dB to +3.0dB
ON
ON, OFF
or
to adjust the setting.
2
Installation
or
or
to select the
11
Hide quick links:
Advertisement
Table of Contents
