Removal And Replacement Of Evaporator; Removal And Replacement Of Water Regulating Valve - Water Cooled Model Only - Hoshizaki KM-1601SWH Service Manual

Stackable crescent cuber
Hide thumbs Also See for KM-1601SWH:
Table of Contents

Advertisement

E. Removal and Replacement of Evaporator
Always install a new drier every time the sealed refrigeration system is opened.
Do not replace the drier until after all other repairs or replacement have been
made.
1) Turn off the power supply.
2) Remove the panels and the top insulation over the evaporator.
3) Recover the refrigerant and store it in an approved container.
4) Remove the spray tubes and the insulations at the "U" shaped notch where the
refrigeration tubings pass through the molded chassis.
5) Disconnect the evaporator tubing.
6) Remove the pop rivets securing the evaporator, lift out the evaporator.
7) Install the new evaporator.
8) Remove the drier, then place the new drier in position.
9) Braze all fittings while purging with nitrogen gas flowing at a pressure of 3 to 4 PSIG.
10) Use an electronic leak detector or soap bubbles to check for leaks. Add a trace of
refrigerant to the system (if using an electronic leak detector), and then raise the
pressure using nitrogen gas (140 PSIG). DO NOT use R-404A as a mixture with
pressurized air for leak testing.
11) Evacuate the system, and charge it with refrigerant. For air-cooled and water-cooled
models, see the nameplate for the required refrigerant charge. For remote air-cooled
models, see the rating label inside the icemaker.
12) Replace the removed parts in the reverse order of which they were removed.
13) Replace the top insulation and the panels in their correct positions.
14) Turn on the power supply.
F. Removal and Replacement of Water Regulating Valve -
Water Cooled Model Only
Always install a new drier every time the sealed refrigeration system is opened.
Do not replace the drier until after all other repair or replacement has been
made.
1) Turn off the power supply.
2) Remove the panels.
3) Close the condenser water supply line shut-off valve, then open the condenser water
supply line drain valve.
IMPORTANT
IMPORTANT


Advertisement

Table of Contents
loading

This manual is also suitable for:

Km-1601swh3Km-1601srhKm-1601srh3

Table of Contents