Using the Detector
The General ML-D3H (GMLD3HDC) detector and clamp can be purchased from
your nearest General dealer.
POWER SUPPLY
The instrument is supplied with one 9v alkaline
•
battery as its standard power source.
Removing & inserting the alkaline battery
Insert the alkaline batteries into the battery tray
•
according to polarity.
Open the battery cover door and insert the
•
battery tray.
Close the battery door.
•
SET UP
Mounting the staff clamp
Insert the staff clamp screw into the staff
•
clamp thread.
Rotate the nut until the clamp is secured
•
in place.
OPERATION
Powering on
Switch the detector on by pressing the power
•
button. The speaker will emit a small tone to
indicate the instrument is operating.
Speaker function
Press the speaker button to turn the speaker
•
off. Press again to turn the speaker on and cycle
between the speaker volumes.
Operation with a multi-line laser level
Move the detector into the path of the
•
laser beam.
Hold the detector upright for horizontal beams
•
(Fig.6) or rotate 90° for vertical beams (Fig. 7).
NOT INCLUDED
The LED direction indicators will indicate the
•
position of the laser beam. The centre LED will
indicate alignment with the beam.
FIGURE 6
FIGURE 7
7