Table of Contents
Advertisement
Using the Tripod
A tripod can be purchased from your
nearest measurement tool dealer. The
below instructions are generic only and
set-up methods may vary between models.
Refer to the documentation from the tripod
manufacturer for details.
Extend the tripod legs to the required height
•
and ensure the legs are spread wide enough
so that the tripod platform is stable. Secure the
legs in place (refer to the documentation from
the tripod manufacturer for details).
Place the laser level onto the tripod and mount
•
via the male thread (5/8" or 1/4") into the base
until firm. Do not over tighten as this may
cause damage to the laser level or tripod.
Care & Maintenance
1. This is a precision measuring tool and should
always be handled with care and transported
within the carry pouch provided.
2. Always turn the tool off when transporting the
laser level or moving around the job site.
3. Whenever possible, store the tool in a dry,
shady location.
4. When the tool is not in use or is being stored,
it is highly recommended to remove the
batteries.
10
NOT INCLUDED
NOTE: adjustment methods will vary on tripod
models. Always ensure that any locking levers are
unlocked before making adjustments and returned
to the locked position when the adjustment is
complete.
If using an elevating tripod with a measuring scale
on the centre column, the height can be adjusted
as required.
!
5. Calibration of the tool is recommended: every
6. The operator should check the accuracy of the
7. Clean the tool with a dry, soft cloth after use in
8. Smudges and fingerprints may be removed
WARNING! Attaching the laser to a
tripod without the correct thread size
may cause damage.
six months, if ongoing accurate levelling is
required, or an impact has occurred.
tool before precision levelling is attempted.
Failure to do so may result in inaccurate
measurements.
dusty, damp or wet conditions before storing.
with a damp tissue or a soft, lint-free cloth.
Advertisement
Table of Contents
