Table of Contents
Advertisement
if Sprayer is not properly cleaned and lubricated immediately after every use.
Clean and lubricate Sprayer immediately to prevent permanent damage.
Problem
Possible Causes
Paint sags or runs.
1. Paint applied too thick.
2. Sprayer too close to workpiece.
3. Uneven or hesitant
4. Excess overlapping of
Blotchy surface
1. Uneven paint application.
(blushing) or
uneven color.
2. Work material absorbs
Spots on surface
1. Improper primer or
with light center
(fish eyes).
2. Surface contamination.
Spots on surface
1. Surface contamination.
with dark center
2. Insufficiently sanded
(contamination).
3. Raised grain.
Item 58520
RETURNS NOT ACCEPTED & WARRANTY VOID
motion of spray gun.
each spray stroke.
paint unevenly.
incompatible surface.
workpiece.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Apply thinner coats, allowing
paint to dry between coats.
2. Hold Sprayer further away from workpiece.
3. Keep spray gun moving.
4. Apply two thin coats rather than one thick
coat. Overlap 1/3 to 1/2 on second coat.
1. Start each stroke off the work material
and overlap each stroke consistently.
2. Use a conditioner or sealer coat
before applying the finish coat.
1. Check manufacturer's recommendations
for primer or compatible surfaces.
2. Clean workpiece thoroughly.
1. Clean workpiece thoroughly.
2. Sand workpiece to a sufficiently
fine grit before painting.
3. Wipe workpiece with thinner to raise grain,
then sand with fine grit to knock off "hairs".
Page 19
Advertisement
Table of Contents
