Getting Started - Interphase Twinscope Operation Manual

Display Unit
12 VDC
Display
Power
Mounting
Cable
Bracket
Transom Mounted Transducers
Thru-Hull Transducer(s)

Getting Started

Check to see that all the components shown at left were
included with your Twinscope. If a part is missing, contact
your dealer or the Interphase Customer Service Department
(831) 477-4944 immediately.
WARNING: DO NOT operate the Twinscope with parts
missing or with parts other than those obtained through
Interphase; doing so could cause a malfunction in the unit. Any
malfunctions to the Twinscope resulting from unauthorized
parts are not covered by warranty.
Turning the Twinscope On
To turn the Twinscope on, press the Power/ Backlight Key
located on the lower right corner of the unit one time. The unit
should sound a beep and the display should be illuminated.
Mounting
Knobs
The Control Center
From the Contol Center the Contrast can be adjusted by
turning the Control Knob cockwise to darken, counter
clockwise to lighten. Seven of the most popular displays have
been pre-programmed into the Twinscope's memory and can be
quickly selected from the Control Center Menu. In the
following sections, these different displays are called "Views".
They include:
Full Screen Forward View
Full Screen Track Plot View
Full Screen Chart (Conventional) View
Full Screen Set-Up View
Split Screen Data View with Large Digits on left and
Forward looking display on right.
Split Screen View with Chart (Conventional) display on
left and Forward looking display on right.
Split Screen View with Chart (Conventional) display on
left and Track Plot display on right.
Each of these views can be easily selected by pressing the
button below the desired menu selection. Where two selections
are possible, press the button again until you see your desired
view. When first turned on, the Twinscope's internal memory
automatically sets the starting view to the last one you used
before turning off the power.
The flow chart diagram page 27 shows how to easily navigate
between the Twinscope's Views. The softkey on the left will
select either the Vertical (Probe) or the Horizontal (Sea Scout)
scanning modes.
24