Interphase Twinscope Operation Manual page 11

Wiring for Power and Transducer
Connectors
The correct pin-out wiring sequences for the power and
transducer connectors are shown at below. DO NOT
SHORTEN THE TRANSDUCER CABLES. If
transducer cables longer than the 30' length supplied with
your unit is needed, please contact your Interphase
dealer. 30-foot scanning sonar transducer extension
cables are available. (P/N # 04-0014-008)
DANGER: Removal of any connector, disassembly of
transducer, shortening of any cable or use of any cable
other than that supplied by Interphase will void your
warranty. NO EXCEPTIONS.
Cable Connectors
plug)
Transducers:
1
2
3
4
5
6
7
8
9
NMEA & SPEED/TEMP Input
1
2
3
4
5
6
7
8
Power Connector
1
2
(view from front of female
White 1st element
Brown 2nd element
Orange 3rd element
Yellow 4th element
Green 5th element
Blue 6th element
Violet 7th element
Gray 8th element
Shield Ground/Return
Speed Data
+5VDC
NMEA Data
N/C
NMEA Return
+ Temp
- Temp
Shield/Ground
+12 vdc (red)
- Ground (black)
Power and Transducer
Connections
vertical transducer cable
speed/temp & NMEA
horizontal transducer cable
Transducer Configurations
SINGLE THRU-HULL
(T1-I200-032)
11
12 VDC
Battery
TWO TRANSOM MOUNTS
TWO THRU-HULL'S
(T1-0200-025 - vertical)
(T1-I200-026 - vertical)
(T1-0200-028 - horizontal)
(T1-I200-029 - horizontal)