Set-Up View - Interphase Twinscope Operation Manual

Set-Up View (Horizontal
Mode)
The Twinscope includes a SET-UP View where the
DEMO program can be activated, the units of measure and
language can be selected and the display contrast can be
adjusted. The Twinscope's internal backup battery will
remember all settings for future use.
From the Control Center press the button below the SET-
UP soft key twice to put the display into the SET-UP
View. Then press the button below the "GO" soft key to
use this view. The display should appear as on the right.
Demo Program
We highly recommend you initially operate the Twinscope
in the DEMO mode to familiarize yourself with the many
advanced features of the Twinscope. When using the SET-
UP view, press the soft key below DEMO and hold for 3
seconds to activate the simulation program. The unit will
automatically cycle through a simulated demonstration of
its many features. At any time, you can press any key to
gain control of the DEMO program to make your own
selections and adjustments. If you do not press any button
for about 45 seconds, the unit will automatically resume
cycling through the different demo features on its own.
The pictures shown in the DEMO mode are representations
of what you might see on your Twinscope. In actual use
the picture you will get can vary significantly depending on
depth, bottom and water conditions, the speed of your boat
and many other factors (see Interpreting The Twinscope's
Forward Display, page 44).
To exit the DEMO program either turn the Twinscope off
and back on again, or press the "DEMO" soft key again.
Select Units of Measure
The Twinscope starts with the last units of measure
selected. By pressing the button indicated on the display,
you can use the large front panel knob labeled "BEAM" to
choose between U.S., Nautical and Metric units. Rotate the
front panel knob to select (highlight) the type of display
s
units desired. Once elected, press any button to save your
selection and exit. The current choice is displayed each
time the "UNITS" soft key is pressed.
47