Configuring The Ethernet Static Address Table - Intermec MobileLAN access WA2XG System Manual

Chapter 3 — Configuring the Ethernet Network

Configuring the Ethernet Static Address Table

60
If you have a secondary LAN, you should configure the Ethernet static
address table in the designated bridge or WAP on the secondary LAN.
This table contains all the MAC addresses on the secondary LAN that are
communicating with the primary LAN. You must enter the MAC
addresses of all devices on the secondary LAN that do not always initiate
communication.
If you choose not to configure this table, the designated bridge or WAP
may need to flood frames to the Ethernet and radio ports to learn the path
to the MAC address.
These addresses become permanent entries in the forwarding table of the
designated bridge or WAP.
To configure the Ethernet static address table
1 In the Navigation Menu, click Ethernet > Static Address Table. The
Static Address Table screen appears.
2 Enter up to 20 MAC addresses. MAC addresses consist of six hex pairs
that are separated by spaces, colons, or hyphens.
3 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 30.
MobileLAN access WA2XG System Manual