Using A Telnet Session - Intermec MobileLAN access WA2XG System Manual

Using a Telnet Session

MobileLAN access WA2XG System Manual
After you have set the initial IP address, you can configure, manage, and
troubleshoot the access point from a remote location using a telnet session.
Only one session can be active with the access point at a time. If your
session terminates abruptly or a new login screen appears, someone else
may have accessed the access point. Also, your session terminates if you do
not use it for 15 minutes.
To use a telnet session
1 Determine the IP address of the access point. If a DHCP server assigned
the IP address, you must get the IP address from the DHCP server.
2 From a command prompt, type:
telnet IPaddress
where IPaddress is the IP address of the access point.
3 Press Enter.
4 If necessary, enter the user name and press Enter. Then, enter the
password and press Enter. The default user name is Intermec and the
default password is Intermec. You can define a user name and password.
For help, see "Setting Up Logins" on page 126. The Access Point
Configuration menu appears.
Chapter 1 — Getting Started
27