Summary of Contents for PerkinElmer LED Solutions ACULED Designer Kit Silver
Page 1
Silver E001790 Product Overview Features and Benefits All-in-one plug and play designer kit • PerkinElmer Elcos offers designer kits Three mounted ACULED RGYBs • that allow you to test and run ACULED® 4-channel power supply 350 mA • products in your application and assess Two lens types •...
Page 2
Table of Contents Revision History Content of the Designer Kit Mounting and Installation of the ACULED® VHL™ / DYO™ Module Operating the ACULED VHL / DYO Module Revision History This table provides a summary of the document revisions. Date Revision Description February 2008 Initial release of document to customers...
Page 3
Content of the Designer Kit Type Product Number Description Quantity Item ACULEDs on Adapter Plate ACULED VHL module ACL01-MC-RGYB-E08-C01-L-R000 RGYB (Red, Green, Blue, Yellow) Soldered on adapter plate (through looking device) ACULED VHL module ACL01-MC-RBG4-E09-C01-L-R000 RBG4 (Red, Green, Blue, White Soldered on adapter plate (through looking device) 4500K) ACULED VHL module...
Page 4
Mounting and Installation of the ACULED® VHL™ / DYO™ Module Short Instruction (for LED Experts) Screw down an ACULED module with thermal grease on an appropriate heat sink. NOTE: Do not apply pressure on the ACULED module encapsulant. This might cause damage to the LED. Connect module with power supply.
Page 5
Screw down the module on a heat sink (fig. 2). NOTE: Pay attention not to angle the screws and not Figure 2 to touch the silicone surface of the ACULED (see Screwing down the ACULED module on a 350 mA heat sink Application Note “Silicone”...